Skip to content

Rainwater vs Tap Water for Plants: Does It Really Matter?

Quick Answer

Evidence & Caution

For most garden plants, it matters less than people think. Tap water in Australia is usually fine for gardens, and rainwater is simply gentler: it is low in dissolved salts and is usually less alkaline. The difference shows up mainly in pots, with sensitive plants, and where your local supply is hard or salty.

If your plants are growing well on tap water, you do not need to change. If you see leaf-edge burn, white crusts on soil or a struggling acid-lover, water quality is worth checking.

What actually differs between rainwater and tap water?

Rain falls close to pure. Tap water has travelled through catchments, treatment plants and pipes, and picks up minerals and treatment chemicals on the way. The size of the difference depends heavily on where you live, so treat the figures below as typical ranges rather than your local numbers.

FeatureRainwaterTap water
pHSlightly acidic, about 5.6 in one garden-science summaryRoughly 6 to 8.5 depending on source
Dissolved saltsVery lowVaries; some supplies are noticeably saltier or higher in sodium
DisinfectantNone from the sky (see tank notes below)Typically chlorine-based
NutrientsSmall amounts of nitrate and ammoniumUsually very little nitrate

The pH and salt figures come from a plain-language summary in The Conversation, which also notes that some supplies carry sodium levels that can harm plants. Sustainable Gardening Australia puts it bluntly: rainwater does not contain salt, unlike bore water and some reticulated supplies.

Be wary of dramatic claims. Other sources quote rain closer to neutral, so the exact pH is not settled, and the nutrient in rain is a small bonus, not a fertiliser. Your water utility’s published water quality report is the best way to learn your own supply’s pH and hardness.

What about chlorine and fluoride?

The evidence here is thinner than the internet suggests. Mains water typically contains chlorine, and a community garden group’s summary says high doses can be toxic to some plants, while The Conversation notes that prolonged watering with water high in chloride, and to a lesser extent fluoride, can interfere with nitrate uptake.

Neither source gives concentrations at which problems start. Most gardeners water happily with tap water, so any risk is likely to be for sensitive species and for long-term use on the same pots, though that is a judgement rather than a measured threshold.

Which plants are most sensitive?

Three groups come up repeatedly.

  • Acid-loving plants. Blueberries are the best documented. University of Georgia Extension explains that alkaline irrigation water, driven mainly by bicarbonate, can gradually lift soil pH above the acidic range blueberries need and reduce access to iron, zinc and phosphorus. That is US horticultural science used for the principle only. Azaleas, camellias and gardenias are often grouped with blueberries as acid-lovers, but I have not found a source here testing them against tap water, so treat that as a reasonable inference. Pale new growth with green veins can hint at a pH problem, though other causes are common.
  • Carnivorous plants. These are the clearest case. A South Australian feature on carnivorous plants says they are sensitive to dissolved salts, especially calcium, and recommends rainwater, distilled water or reverse osmosis water. It adds that hard water is risky when pots stand in trays, because salts concentrate as the water evaporates. Free-draining Nepenthes are described as the exception.
  • Salt-sensitive crops and shrubs. Sustainable Gardening Australia lists strawberries, avocado, citrus, carrots, onions, roses and camellias as highly sensitive, citing Western Australian agriculture department lists. If you have a salty bore or a hard supply, these are the first to show it.

Indoor plants in small pots can also suffer, simply because there is less soil to dilute whatever builds up.

How does salt build up in pots, and how do you fix it?

Every time you water, the plant takes up water and leaves most dissolved minerals behind. Evaporation from the pot surface concentrates them further. In open ground, heavy rain flushes salts deeper below the roots. A pot has no such escape unless you provide one.

Warning signs include:

  • white or tan crusts on the soil surface or pot rim
  • brown, crisp leaf tips and margins
  • wilting even though the mix is moist

The cause is not always water. Fertiliser adds salts too, as University of Illinois Extension notes, and burned leaf margins and injured roots are the result of heavy build-up.

To flush a pot:

  1. Move it outdoors or to a sink or tray.
  2. Water slowly until water runs freely from the drainage holes.
  3. Let it drain fully, then repeat once or twice with fresh water over the next hour.
  4. Scrape off any surface crust and keep the saucer empty.
  5. Go back to normal watering and use a lighter hand with fertiliser.

The flush works only if water can pass through the mix. Compacted or very dry, hydrophobic potting mix sheds water down the sides, so soak it first. For wider guidance on frequency and depth, the main guide to watering Australian gardens covers the basics.

Gardens in heavy soil can have a related problem, where sodium locks up clay and water cannot drain. That is a soil structure question, covered in the article on gypsum and clay soils.

Does letting tap water stand overnight help?

Partly, and only for one thing. The popular advice is that chlorine escapes if water sits for a while, and that is broadly true for plain chlorine. It does not remove minerals, hardness or alkalinity, so it does nothing for salt or pH problems.

Some water suppliers use chloramine instead, which is generally described as more persistent. Check your utility’s information to see what you receive rather than guessing. I could not confirm a reliable timeframe from an authoritative horticultural source, so I have not given one. Stored water also loses some of its dissolved nitrate over time, according to the community garden summary above, which is a minor point against keeping it for weeks.

The simple conclusion is that standing tap water costs nothing and may help a little with chlorine, but it will not turn hard water into rainwater.

How do you use tank water well?

Tank water is the easy route to low-salt water, with a few practical cautions. These are gardening observations, not rules about tanks or drinking supplies.

  • Use it where it counts first. Give tank water to pots, indoor plants, carnivorous plants and acid-lovers. Use tap water on tough in-ground plants when the tank runs low.
  • Expect variation. Roof material, nearby trees, bird droppings and a long dry spell can change what ends up in the tank. Wash leaf litter and grit out of watering cans and keep the tank screened.
  • Watch for stale water. Smelly or discoloured water from the bottom of a tank is better used on mulched garden beds than on seedlings or indoor plants.
  • Do not skip flushing. Rainwater lowers the salt load but fertiliser still builds up in pots, so keep flushing every few months.
  • Water to the soil, not the leaves in humid weather, since wet foliage encourages fungal problems.

In the tropics and subtropics, wet-season rain refills tanks often and frequent downpours naturally flush in-ground soil. In temperate and arid regions, dry stretches mean tanks run low and salts concentrate in pots faster, so flushing matters more. In cool highlands and Tasmania, slower evaporation means less build-up, though pots still need an occasional flush.

Common mistakes

  • Switching to rainwater and expecting an obvious leap in growth. Most healthy plants will not show a difference.
  • Assuming white crust is always a fertiliser problem. Water and fertiliser both contribute.
  • Using a softened supply on plants. Illinois Extension recommends well water or another naturally collected source over softened water.
  • Standing pots in saucers of hard water all week.
  • Flushing a bone-dry pot without soaking it first.

So, does it really matter?

For an established garden on a decent supply, no. For pots, acid-lovers, carnivorous plants and anyone on a hard or salty supply, yes. Catch rain where you can, flush pots regularly, and treat leaf burn and white crust as the signals to act on. For a related situation where new plantings struggle, see the guide to watering new plants through establishment.

Sources

No comment yet, add your voice below!


Add a Comment

Your email address will not be published. Required fields are marked *